RC Box Speed Controller Programming Instructions
For ESC with simple options
20A / 30A / 40A
Programming Instructions:
1. Connect your motor and receiver to the speed controller, bus do not connect the battery yet.
2. Turn on your transmitter and full up the throttle stick. Please Note : Most Futaba transmitters have the throttle channel reversed by default.
3. Connect your battery and you will hear a starting beep tone. After 3 seconds, the controller will start beeping a sequence as following. All beeps only repeat once.
4. To select, move the throttle stick in off position, between beeps repeat. Then you will hear a confirmation sound.
5. Each time when you select an option, it will exit Programming menu, You may restart Program again.
Options Table (for Aircraft version
|
|
Beeping (with 0.5s break) |
Options |
|
|
1 |
▬,▬ |
Cell Type: LIPO |
ESC identify the number of LIPO and set LIPO protection automatically Cut-off voltage at 3V per Lipo (Option Two will be disable automatically) |
|
2 |
▬▬,▬▬ |
Cell Type: NiMH |
Select NIMH protection mode Cut-off voltage at 60% of startion voltage (option Two will be disable automatically) |
|
3 |
▬▬▬,▬▬▬ |
Break Enable/ Disable |
Break enable by Default |