상품상세설명

These Team Durango moulded cross shafts fit the differentials in all Team Durango 1/8th scale models.

They replace the steel cross shafts and inserts in the differential, offering a huge reduction in weight over the steel parts.

The moulded parts are 80% lighter than the steel parts they replace, giving a total weight saving of 22.2g per vehicle.

They have been extensively tested by our pro team who found an increase in acceleration and breaking performance due to a reduction in the rotating mass of their transmission.The testing has shown that there is no detrimental effect in durability when using these moulded parts.

Pro driver Ryan Lutz says It is unbelievable the difference these parts make. The first time I ran these parts I was amazed by the extra acceleration from my DNX408.

These lightweight cross shafts also fit many other manufacturers differentials. The cross shafts are 3.5mm in diameter, and 27mm in length.

Supplied in a set of 3, enough to replace the cross shafts and differential inserts in the front, centre and rear differentials in a vehicle.

This Part Fits On	Standard Part	Option Part
DEX408T 1:8 Electric 4WD Truggy See the Kit Page | See all Standard Parts | See all Option Parts
DNX408T 1:8 Nitro 4wd Truggy kit See the Kit Page | See all Standard Parts | See all Option Parts
DEX408 1:8 Electric 4WD Off Road Buggy See the Kit Page | See all Standard Parts | See all Option Parts
DNX408v2 1:8 Nitro 4WD Off Road Buggy See the Kit Page | See all Standard Parts | See all Option Parts