Holybro Tekko32 F4 Metal 65A 4in1 ESC (AM32)

- »óÇ°¼³¸í ÁغñÁßÀÔ´Ï´Ù.

±¸¼º

ÇÏ´Ü »çÁø ÂüÁ¶

F4 MCU @150Mhz / Metal-Cased MOSFET / PWM output: 16k ~96k PWM / 4~6S / AM32_Firmware

The all new Tekko32 Metal is the first 4in1 ESC in the market to adapt the fast F4 MCU.

Powerful & reliable metal-cased MOSFET 4in1 ESC with smooth control and quick response.

Features

New & faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz)

PWM Frequency: 16k to 96k

Metal-cased MOSFET for excellent heat dissipation

Massive on-board capacitance for noise filtering at 2068uf

3 oz copper PCB design to allow bigger current and better heat dissipation

Separate drive & control circuit, this broadens the current capability of the drive circuit while reducing the electrical interference to the control circuit.

Specification

Continuous Current: 65A x4

Burst Current: 75A x4

Supports 4-6S battery

Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc.

ESC telemetry Supported

Onboard analog current sensor

No output BEC

AM32 firmware

1000uf 35v capacitor included (highly recommended for 6s setup)

Amperage meter scale ratio: 180

Dimensions: 43 x 44mm / Weight: 15.8g

Mounting holes: M4 30.5x30.5mm (M3 grommets included)

Note

Air flow for the ESC is very important if you want to run this 4in1 in high current.

The battery wire (from Lipo to 4in1 ESC) should be at least 12AWG and well soldered.

PIN MAP

Package included

Tekko32 F4 Metal 4in1 65A ESC *1

M3 Anti-Vibration Silicone Grommet Insert *4

Electrolytic capacitor: 1000uF 35v *1

8pin to 8pin 1mm pitch 65mm cable *1

8pin to 8pin 1mm pitch 25mm cable *1