Kakute F722 + Tekko32 F4 50A ESC Stack

- FC¿Í ESC ÄÞº¸ »óÇ°ÀÔ´Ï´Ù.

- Kakute F722 FC¿Í Tekko32 F4 50A ESCÀÔ´Ï´Ù.

- ICM42688P ÀÚÀ̷θ¦ »ç¿ëÇÕ´Ï´Ù.

- BLHeli_32ºñÆ® Æß¿þ¾î¸¦ »ç¿ëÇÕ´Ï´Ù.

±¸¼º

ÇÏ´Ü »çÁø ÂüÁ¶

Kakute F722 FC

Feature

• High-performance STM32 F722 MCU with speeds up to 216MHz.

• ICM42688P gyroscope, independent low-noise power supply.

• Various Ports for quick & easy setup: ESC port, Digital VTX port, Analog VTX port, Receiver port, and LED port.

• Built-in analog video OSD, 16 Mbytes black box,

• High power synchronous rectifier BEC, supports up to 8S input and provides stable 9V/3A & 5V/2A output.

Specification

MCU: STM32F722 32-bit processor, 216MHz, 256Kbytes RAM, 512Kbytes Flash

IMU: ICM42688-P (SPI)

Barometer: BMP280

OSD: AT7456E

5x hardware UARTS (UART1,2,3,4,6)

7x PWM Outputs (6 Motor Output, 1 LED)

Onboard 16 Mbytes for Blackbox logging

Battery input voltage: 3S - 8S

BEC: 9V/3A, 5V/2A, 3.3V/0.2A

Connector

• 2x JST-SH 8pin port for ESC

• 1x JST-SH 6pin port for HD VTX

• 2x JST-SH 4pin port for Receiver & Analog Camera

• 1x JST-SH 3pin port for LED

USB Type -C

Dimensions: 35x35mm

Mounting Holes: Standard 30.5 x 30.5

Weight: 8g

Firmware Targets

• Betaflight Target: KAKUTEF7MINIV3

• INAV Target: KAKUTEF7MINIV3
  

Tekko32 F4 4in1 50A ESC
Fast F4 MCU @150Mhz / PWM output up to 96K / 4~6S / BLHeli32 / 30x30

Features

New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz)

PWM Frequency: 16k to 96k

Separate drive & control circuit, this broadens the current capability of the drive circuit while reducing the electrical interference to the control circuit.

Specification

Continuous Current: 50A x4

Burst Current: 60A x4

Supports 4-6S battery

Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc.

ESC telemetry Supported

Onboard analog current sensor

No output BEC

BLHeli_32 firmware

1000uf 35v capacitor included (highly recommended for 6s setup)

Amperage meter scale ratio: 120 (V1.9 Version)

Dimensions: 48x37x6mm / Weight: 13.8g

Mounting holes: M4 30.5x30.5mm (M3 grommets included)