[´Ý±â]
¡Ù »óǰ °Ë»ö °á°ú
°Ë»ö Áß... 

ÀÏÄ¡ÇÏ´Â »óǰ¸íÀÌ ¾ø½À´Ï´Ù.
Á¤¹Ð °Ë»öÀ» ÇϽ÷Á¸é ¾Æ·¡ ¹öưÀ» ´­·¯ÁÖ¼¼¿ä.

Àüü °Ë»ö
¡Ù ºÐ·ù °Ë»ö °á°ú
¾Ë¸²
Àüü ºÐ·ù TOP Àå¹Ù±¸´Ï ÃÖ±Ùº»»óǰ
[HOLYBRO] ÇȽºÈ£Å© 5X, 6X ÆÄ¿ö ¸ðµâ PM02D (12S HV) - ÇÏÀÌ º¼Æ® °íÀü¾Ð¿ë µðÁöÅÐ ¼¾¼­
Pixhawk Digital Power Module (PM02 D)
ÀϹݰ¡°Ý : 46,700 (ȸ¿ø °¡ÀԽà Ãß°¡ ÇÒÀÎ)
Àû¸³±Ý : 460¿ø
¹°·ùâ°í :
A
E
Àç°í : ÃѾ˹è¼Û 7°³ + ¹°·ùâ°í Ãß°¡ Àç°í ¡Ä°³
»óǰ¹øÈ£ : QA79780 (¡ØÀüÈ­¹®Àǽà »óǰ¹øÈ£¸¦ ¾Ë·ÁÁÖ¼¼¿ä)
À§¿¡¼­ ¿É¼ÇÀ» ¼±ÅÃÇϼ¼¿ä.
±¸¸Å ¼ö·®
¹Ù·Î±¸¸Å
Àå¹Ù±¸´Ï
½Ç½Ã°£ Ä«Åå ¹®ÀÇ

Àå¹Ù±¸´Ï¿¡ ´ã¾Ò½À´Ï´Ù.
Áö±Ý È®ÀÎÇϽðڽÀ´Ï±î?
  
À̹ÌÁö »óǰ¸í ¼±ÅÃ
±âŸ ÇÊ¿äÇÑ ¿É¼Ç»óǰ ÃÑÇÕ°è:
0¿ø
¿É¼Ç »óǰÀ» Æ÷ÇÔÇÏ¿© Àå¹Ù±¸´Ï ´ã±â >

[Holybro] PM02D Power Module (12S HV Type)




[ÆÓÄܼ¥] HOLY-15011 [HOLYBRO] ÇȽºÈ£Å© 5X, 6X ÆÄ¿ö ¸ðµâ PM02D (12S HV) - ÇÏÀÌ º¼Æ® °íÀü¾Ð¿ë µðÁöÅÐ ¼¾¼­
Note
- PM02D HV version is supported by PX4. For Ardupilot, it is supported in Ardupilot latest/master FW, or version 4.4 and later. 
- This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.


PM02D provides regulated power supply for your Pixhawk? 5X & 6X from the battery,  as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S (LV) or 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.

It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification

  • Input voltage 
    • HV: 2S-12S 
  • PCB Cont. Current Rating: 60A
  • PCB Burst Current Rating: 100A (<60 Sec)
  • Max current sensing:
    • HV: 327A 
  • Voltage and current monitor with I2C compatible interface 
  • Outputs 5.2V and 3A max 
  • Weight: 20g

[ÆÓÄܼ¥] HOLY-15011 [HOLYBRO] ÇȽºÈ£Å© 5X, 6X ÆÄ¿ö ¸ðµâ PM02D (12S HV) - ÇÏÀÌ º¼Æ® °íÀü¾Ð¿ë µðÁöÅÐ ¼¾¼­

Current Rating:

The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference.

PIN MAP:

[ÆÓÄܼ¥] HOLY-15011 [HOLYBRO] ÇȽºÈ£Å© 5X, 6X ÆÄ¿ö ¸ðµâ PM02D (12S HV) - ÇÏÀÌ º¼Æ® °íÀü¾Ð¿ë µðÁöÅÐ ¼¾¼­

PX4 Parameter Setup:

If you are using the PM02D HV version, you must set SENS_EN_INA228 to enable.

Package Includes£º

1x  PM02D Power Module
1x  6pin 2.00mm pitch cable


[ÆÓÄܼ¥] HOLY-15011 [HOLYBRO] ÇȽºÈ£Å© 5X, 6X ÆÄ¿ö ¸ðµâ PM02D (12S HV) - ÇÏÀÌ º¼Æ® °íÀü¾Ð¿ë µðÁöÅÐ ¼¾¼­



°í°´ ¼¾ÅÍ

Á¦Ç° ¹®Àǽà »óǰ¹øÈ£¸¦
È®ÀÎÇØ ÁÖ¼¼¿ä!

051-868-7187
  • »ó´ã½Ã°£ : 10:00 ~ 18:00
  • Á¡½É½Ã°£ : 12:00 ~ 13:00
  • ÁÖ¸», °øÈÞÀÏÀº ÈÞ¹«ÀÔ´Ï´Ù.

BANKING
INFOMATION

±¹¹ÎÀºÇà 114037-04-007320
³óÇù 301-4743-6265-11

¿¹±ÝÁÖ : (ÁÖ)ÆÓÄܼ¥