① 99.9% 실재고 관리매일 밤 자동 갱신, 유령 재고 NO! 보이는 수량이 진짜입니다.
② 22년 전문가 직답국내 최고 전문가가 막힘없이 즉시 해결해 드립니다.
③ 확실한 기술 지원국내 최고 수준의 노하우로 막힘없는 솔루션을 제공합니다.
④ 출고 전 전수 촬영출고 전 제품 사진 기록으로 오배송 및 누락을 원천 차단합니다.
⑤ 실시간 배송 일정주문 확인 즉시 발송 예정일을 카톡으로 먼저 알려드립니다.
⑥ Since 2004 신뢰22년을 한결같이 지켜온 믿음. 걱정 없이 이용하세요.
RadioMaster R81 2.4GHz 8CH Over 1KM SBUS
Nano Receiver Compatible FrSky D8 Support Return RSSI for RC Drone
- TX16S용 수신기입니다.
- KC인증 : R-R-ssr-R81V2
구성
R81 V2 수신기 1개
기존의 R81 과 동일한상품입니다.
V2는 뜨거운온도에서의 내구성이 약간 상승하였다고 보시면 되겠습니다.
라디오마스터 수신기입니다.
Frsky D8모드를 사용하는 모든 조종기에 사용하실 수 있습니다.
SBUS방식의 8채널 수신기입니다.
Description
Weight : 2g
Size : 17*11 mm
Channels : 8CH
Frequency range : 2400-2483.5Mhz
Power input range : 4.5-6V
Signal format : FrSky D8 Compatible
Output format : SBUS
Support return : support return RSSI
Control distance : more than 1km
Antenna length : Approximaltly 6cm
Bind method
1. Press and hold the BIND button on the receiver then connect power. After approximately 3 seconds, the receiver LED will be RED, the receiver is now in bind mode
2. Select the D8 protocol for the multi-protocol menu of your remote control, and press the [BIND] option, the red light of the receiver will flash indicating successful bind
3. Exit bind mode on your remote control and disconnect power to the receiver then power the receiver once more. The LED will now be solid RED indicated the bind is now done. If not please repeat step 1 and 2
Fail-safe Protection
1. Press the BIND button once within 10 seconds of th eceiver being powered on, and the receiver will save all the current channel values of the remote control as the fail-safe value
2. 10 seconds after the receiver is powered on, the BIND button function will be disabled to prevent accidental changes to to the fail-safe settings while preparing the model for flight
RSSI output
This receiver has a total of 9 channels. 8 channels + an RSSI output channel.
Channels 1-8 are controlled by the remote controller, the 9th channel is the signal strength RSSI value output by the receiver itself, which can be read by the flight controller and sent to the OSD device Show