This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

Specifications： 

. Input voltage: 2S-10S

. PCB Cont. Current Rating: 70A

. PCB Burst Current Rating: 120A (<60 Sec)

. Output: DC 5.2V & 3A Max 

. Ouput Max Power : 18W

. Voltage Divider: 18.182

. Amperes per Volt: 36.364 

- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 

- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 

Mechanical Specification:

Dimensions: 35x35x5mm

Mounting hole: 30.5mm*30.5mm

Weight: 24g